亲子乱高潮1000部,色婷婷五月综合亚洲小说,禁伦H肉高辣网站视频,亚洲成av人影院

儀器簡介：

Nonlinearity (% of F.S.)

=< ±0.15

=< ±0.07

Hysteresis (% of F.S.)

=< ±0.15

=< ±0.07

Nonrepeatability (% of F.S.)

=<±0.07

=< ±0.03

Accuracy (combined Nonlinearity， hysteresis and nonrepeatability， % of F.S.)

=<±0.15

=<±0.08

Stability， 6 Months (% of F.S.)

=<±0.20

=<±0.10

Rotational Effect on Zero (% of F.S.)

=<±0.10

=<±0.03

Calibration Accuracy (% of F.S. @ 75 deg F， traceable to NIST)

=<±0.05

=<±0.02

Temperature Effects:

Zero (% of F.S./deg. F.)

=<±0.003

=<±0.0015

Span (% of Rdg./deg. F.)

=<±0.003

=<±0.0015

Compensated Range

+75 to +175 deg. F

+75 to +175 deg. F

Minimum Useable Range

-25 to +185 deg. F.

-25 to +185 deg. F.

Storage Range

-65 to +225 deg. F.

-65 to +225 deg. F.

Zero Balance

=<±1% of F.S.

=<±1% of F.S.

Outputs: Fully bi-directional， dual outputs with characteristics as follows:

Clockwise (CW) Torque

+ 5 Volts

Counterclockwise Torque (CCW) Torque

- 5 Volts

Overrange (% of F.S.)

±33

Measurement Bandwidth:

High Frequency， dc to 500 Hz

Low Frequency， dc to 1 Hz

Power Supply Requirements:

10.5 to 24 Volts dc at 85 mA， nominal

技術參數：

扭矩范圍：0.071-452400N-m， 過載：200%

信號輸出：±5V，±10V，可以直接連接到PC，PLC或數據采集器

頻率響應范圍：1-500Hz

主要特點：

DC Operated Torquemeters are available in capacities from 25 lbf-in to 4，000，000 lbf-in with overload ratings of 2X full scale. Integral signal conditioning provides dual ±5 volt dc outputs proportional to torque. They will operate from a single power supply in the range of 10.5 to 24 volts dc (such as 12 volt batteries)

When installed between a driver and load， the sensor will measure static and dynamic shaft torque and speed (optional). A strain gaged stainless steel shaft senses torque and cancels bending and thrust. Robust， ferrite free rotary transformers connect the gages to noise immune carrier amplifiers. They don't generate noise or wear， are immune to magnetic fields， noise， vibration， lubricants and other hostile environments.

They are available in either shaft or flanged style configurations. Shaft end torquemeters are less costly than flanged models and can be either floated or foot mounted. Flanged models are much shorter and can be used when axial space is limited or when the highest shaft stiffness is needed